Unless otherwise stated, delivery without content/ accessories. The offers are only valid for commercial customers. All prices excluding VAT. Hand tools Nominal voltage range Article no. EUR CK 400–500 V AC 4000 828 843 66,95 WX15 Phase-sequence indicator TRITEST® pro Displays „clockwise” and „counterclockwise” field of rotation via green/red LED · Displays phase voltages L1, L2 and L3 via red LED Measuring ranges: · Voltage range: 400 V–500 V AC (50 Hz–-60 Hz) · Measurement category: CAT lll 300 V Display stages: LEDdisplay for high-ohmresistances up to90 kΩ, for low-ohmresistances up to900Ω Polarity detection for semiconductors (diodes, transistors) Test current < 0,00006 A VDE-tested and approved Scope of supply: Phase-sequence indicator, 4 mm test tip set and alligator clip, magnetic holder and belt clip Supplied without batteries (requires 3 Mignon batteries / AA), batteries see article no. 4000 901 811 Article no. EUR CK 4000 828 811 49,95 WR01 Socket tester SDT 1 Fast and easy checking of sockets with earthing contact for correct connection · Wiring faults, such as missing PE, N and L leads as well as commutating L and PE leads, are clearly indicated via 3 LEDs · Active PE test with touch electrodes and LC display warns against being in contact with a dangerous touch voltage (> 50 V) on the protective conductor terminal (PE) · Test button to trigger the 30 mA FI/RCD circuit breaker · Unambiguous readings via LEDs and LC display · Easy to understand status table informs of correct connection (OK, green) and the nature of the existing fault (red) in the socket with earthing contact · Measurement category CAT III 300 V Measuring technique Article no. EUR CK RMS 4000 828 857 58,95 WB05 Multimeter MM P3 In bag format · With 3 1/2-digit LC display (4,000 points) · Integrated measured value memory · 130 g light · Automatic or manual measuring range selection · Battery, low voltage indicator · Continuity and diode testing · CAT III 300 V, CAT II 600 V Measuring ranges: Direct voltage: 100 µV–600 V, alternating voltage: 100 µV–600 V, resistance: 0.1 Ω–40 MΩ, capacitance: 10 pF–100 µF, frequency: 0.001 Hz–5 MHz Supplied with batteries (2 button batteries LR44), protective case, fixed 2-mm measuring leads; replacement batteries, see article no. 4000 901 744 Measuring technique Article no. EUR CK RMS 4000 828 947 115,00 WB05 Multimeter MM 1-2 With 3½-digit LCD display (2,000 points) and volt sensor · Integrated volt sensor signals non-contact phase voltages and cable breaks in lines (optical/acoustic) · Single-pole phase testing · Automatic and manual range selection · Measured value memory (HOLD), maximum/minimum value memory (MAX/MIN) · Continuity and diode testing · Automatic switch-off · Measurement category: CAT III 600 V, CAT II 1000 V Measuring ranges: Direct voltage: 0.1 mV–1,000 V, alternating voltage: 0.1 mV–750 V, direct current: 1 mA–10 A, alternating current: 1 mA–10 A, resistance: 0.1 Ω–20 MΩ, frequency: 1 Hz–20 MHz, capacitance: 1 pF–2 mF Scope of supply: Supplied with batteries (2 x type AAA), measuring leads and bag, replacement batteries see article no. 4000 901 810 Measuring technique Article no. EUR CK RMS 4000 828 860 129,00 WB05 Multimeter MM 1-3 With 3½-digit LCD display (2,000 points), volt sensor and temperature measurement · With battery low voltage indicator · Automatic and manual range selection · Volt sensor for non-contact detection of the phase voltage (optical/acoustic) · Localises interruptions, e.g. in exposed wires, cable drums · Continuity and diode testing · Single-pole phase testing · Automatic switch-off · With integrated measured value memory, maximum/minimum value memory (MAX/MIN) · CAT III 600 V, CAT II 1000 V Measuring ranges: Direct voltage: 0.1 mV–1,000 V, alternating voltage: 0.1 mV–750 V, current: 1 mA–10 A, resistance: 0.1 Ω–20 MΩ, capacitance: 1 pF–2 mF, frequency: 1 Hz–20 MHz, temperature: -20 °C to +800 °C Supplied with batteries (2 x 1.5 type AAA), measuring leads, instrument case, wire temperature probe with adapter; replacement batteries, see article no. 4000 901 810 Measuring technique Article no. EUR CK RMS 4000 828 863 99,95 WB05 Multimeter MM 1 With 3½-digit LCD and bar graph display (3,200 points) · With polarity and battery low voltage indicator · Automatic and manual range switching · Continuity and diode testing · With integrated measured value memory · CAT III 600 V Measuring ranges: Direct voltage: 0.1 mV–600 V, alternating voltage: 1 mV–600 V, resistance: 0.1 Ω–32 MΩ, direct current: 0.1 μA–3.2 mA Supplied with protective frame, batteries (2 x type AAA), measuring leads, and instrument case; replacement batteries, see article no. 4000 901 810 6/15
RkJQdWJsaXNoZXIy ODY1MjQ=