Unless otherwise stated, delivery without content/ accessories. The offers are only valid for commercial customers. All prices excluding VAT. Hand tools Nominal size Opening A [mm] Opening B [mm] Suitable pulling device Article no. EUR CK 0 8– 60 60 Article no. 4157 490 000 4157 490 010 70,95 WC28 1 12– 75 75 Article no. 4157 490 001 4157 490 011 90,95 WC28 2 22–115 115 Article no. 4157 490 002 4157 490 012 145,00 WC28 3 25–155 155 Article no. 4157 490 003 4157 490 013 229,00 WC28 4 30–200 200 Article no. 4000 767 070 4157 490 014 649,00 WC28 5 30–250 250 Article no. 4000 767 071 4157 490 015 925,00 WC28 Separating device 15 Application: For pulling off ball bearings, roller bearings, inner races and other flush-seated parts · The sharp cutting edges enable the pulling-off of flush parts, where 2-armed and 3-armed pullers cannot be used (Fig. 1) · The clamping of the separating jaws is implemented through uniform loosening of the nuts on the side bolts Working principle: The stripping is implemented through tightening the spindle against the shaft end (Figure 2 and 3), in case of the large pulling devices, hydraulic operation is also possible Working principle with hydraulics (Figure 4): (Hydraulics not included in the scope of supply) Screw the spindle of the hydraulics into the screw thread of the traverse of the pulling device with the spanner (b) · Until the pressure piece presses securely against the shaft, then activate the hydraulics by rotating the upper spindle (a) Caution: Figures 2 and 3 show the separating device in combination with the pulling device article no. 4157 490 000, 4157 490 001, 4157 490 002, 4157 490 003 (not included in the scope of supply) Figure 4 shows the separating device in combination with the pulling device article no. 4157 490 000, 4157 490 001, 4157 490 002, 4157 490 003 and a hydraulic spindle (pulling device and hydraulic spindle not included in the scope of supply) Hydraulic spindle, please enquire separately Abb. 4 Fig. 2 Fig. 3 Contents Nominal size Packaging Article no. EUR CK 1 separating device size 0, 1 pulling device size 0, 2 extensions size 1 0 I-Boxx 4157 503 003 235,00 WC28 1 separating device size 1, 1 pulling device size 1, 2 extensions size 1 1 I-Boxx 4157 503 103 329,00 WC28 1 separating device size 2, 1 pulling device size 2, 2 extensions size 2 2 L-Boxx 4157 503 203 439,00 WC28 1 separating device size 3, 1 pulling device size 3, 2 extensions size 3 3 Steel case 4157 503 303 605,00 WC28 Separating device set Complete fittings · With separating device, pulling device and extension Application: For pulling off ball bearings, roller bearings, inner races and other flush-seated parts Supplied in case 6/249 SDB 4157 503 003 4157 503 303 4157 503 203 4157 503 103
RkJQdWJsaXNoZXIy ODY1MjQ=